Page 1 of 1

Lemur OSC input from Osculator

Posted: 10 Jan 2018 00:45
by apacherose105
I am basically trying to set up bi-directional feedback from my Behringer X32 rackmount mixer back to Lemur. So say when I change my Main LR Out level on the front panel of the rack, the fader I have set up in my Lemur template follows the level of the knob. I have gotten Lemur to send OSC to the X32 via Lemur using the osc.udp://"ip address of the mixer":10023. as a target in OSCulator.

I have followed the details on how to get the x32 to spit back OSC data I found in this video. https://www.youtube.com/watch?v=ylnGLB3ozog

My master level is showing up as /min/st/mix/fader which is correct. I just can't figure out how to get it to send back to Lemur. I know that Lemur is hard coded to listen on OSC port 8000.

What are my next steps?