Liine Forum

Hi !

After solving that issue :
https://forum.liine.net/viewtopic.php?f=32&t=951

Daemon config is empty after pc boot and I must add again the midi I/O ! I delayed daemon boot from 15s to be sure it starts after every other applications such as loopmidi. But no luck. Daemon is the last to start, now though...

I'm pretty sure this issue happend to other lemur users but I can't find any info, even on this forum !

If anyone could give me some info or help, it would be nice ! And I would thank him ! (Yes I will !)

PS : I posted a topic like this one in general discussion, but I believe its place belongs to troubleshooting......

Thanks for your attention !

Yeah !

I am very proud of myself !

By delaying daemon start up from 15s, thanks to 'Startup Delayer' free utility, it starts with its config. I think the issue comes from the fact that it started BEFORE loopmidi !

So, for those who want to do the same : install 'Startup Delayer', set daemon with 15s delay, untick "launch daemon on startup" and untick daemon in msconfig too This is important, otherwise, daemon still start on pc boot before loopmidi !

Normally, it works fine.