Unusable Latency w/ onMIDI Scripts
Posted: 22 May 2016 04:07
Setup:
iRig MIDI, 30 pin
iPhone 4 or iPad2, same result
Could any of you folks tell me what is the very quickest way to pass a DIN MIDI message straight through the Lemur app and back out the h/w DIN MIDI output of a physically connected iOS MIDI Interface(i.e. iRigMIDI)? Please have a look at this basic template, w/ two onMIDI scripts, passing NoteOn/Off from MIDI1 In(iRig) to MIDI1 Out (iRig) out. The latency is unusable. Listen to these audio files. They were created with a pair of h/w synths w/ similar patches, panned hard right & left.
http://www.neilnappe.com/stuff/Lemur/Straight-Lemur.wav
http://www.neilnappe.com/stuff/Lemur/MIDI_Bridge.wav
Straight-Lemur.wav is Synth1 MIDI Out direct to Synth2 MIDI In, 10 Notes; followed by Synth1 though iPad/Lemur & attached template out to Synth2, 10 notes
MIDI_Bridge.wav is Synth1 through iPad/MIDI Bridge app,w/ iRig In patched to iRig Out, 10 Notes. NO AUDIBLE LATENCY, so it's NOT my iPad or the iRig.
WTF???? Am I just going about this totally wrong? Is there another way to pass MIDI data through Lemur without this unacceptable latency?? I sure hope I screwed something up...
Really appreciate any thoughts on this, thanks.
iRig MIDI, 30 pin
iPhone 4 or iPad2, same result
Could any of you folks tell me what is the very quickest way to pass a DIN MIDI message straight through the Lemur app and back out the h/w DIN MIDI output of a physically connected iOS MIDI Interface(i.e. iRigMIDI)? Please have a look at this basic template, w/ two onMIDI scripts, passing NoteOn/Off from MIDI1 In(iRig) to MIDI1 Out (iRig) out. The latency is unusable. Listen to these audio files. They were created with a pair of h/w synths w/ similar patches, panned hard right & left.
http://www.neilnappe.com/stuff/Lemur/Straight-Lemur.wav
http://www.neilnappe.com/stuff/Lemur/MIDI_Bridge.wav
Straight-Lemur.wav is Synth1 MIDI Out direct to Synth2 MIDI In, 10 Notes; followed by Synth1 though iPad/Lemur & attached template out to Synth2, 10 notes
MIDI_Bridge.wav is Synth1 through iPad/MIDI Bridge app,w/ iRig In patched to iRig Out, 10 Notes. NO AUDIBLE LATENCY, so it's NOT my iPad or the iRig.
WTF???? Am I just going about this totally wrong? Is there another way to pass MIDI data through Lemur without this unacceptable latency?? I sure hope I screwed something up...
Really appreciate any thoughts on this, thanks.