Do we have some touchosc users here? What do you do in Lemur to mimic or replace the XY pads?
I'm using a multiball with a single ball but it's difficult because the z parameter stays on unless I set it to ephemeral, in which case I lose my display of position unless touching the ball. So I can't have the ball constantly displayed and also use the Z to operate a router in Reaktor like I can with TouchOSC.
I'm trying something with an ephemeral multiball and a signal scope for the display but it's difficult going. Any tips would be appreciated.
Approximating TouchOSC Xy pads
-
peterdines
- Newbie
- Posts:42
- Joined:08 Dec 2011 16:23
-
wetterberg
- Newbie
- Posts:31
- Joined:21 Dec 2011 01:37
Re: Approximating TouchOSC Xy pads
your z parameter stays on? that's odd, I can't reproduce that, neither on the legacy nor on ipad or iphone.
-
peterdines
- Newbie
- Posts:42
- Joined:08 Dec 2011 16:23
Re: Approximating TouchOSC Xy pads
I think it's a bug. I came back to it later and it was mysteriously working again. Think it has something to do with a long heavy development session in the Lemur editor with Lemur connection active. Or possibly an ID-10-T problem. 